|Re: Dead CC2 station ? Kategorie: CC2-Unit & Appl.Board / CC2-Station (von Detlef - 8.11.2016 15:48)|
Als Antwort auf Re: Dead CC2 station ? von Philippe - 7.11.2016 14:20
> > Hello Philippe,|
> > it seems, that the Control Station is dead. Normaly the station should react, you hear the relais
> > and see all LED lighting during boot up.
> > Do you try with 12V power? Or do you use the 220 AC voltage connect?
> > If you need a new running spare part, i have some of them on stock, because of my own C-Control
> > instalation...
> > With best regards,
> > Detlef JÃ¼rrens
> Hi again,
> I made some controls; the 12V and 5V are OK.
> One correction: all LEDs are lit immediately at power on and stay like this.
> No relay sound at power on.
> Q: Is there some manuals in English?
> Q: Is this unit is serviceable somewhere?
> Conrad France says only that "the manufacturer does not give any information on this product".
> Q: The firmware is in flash? Is there some possibility to lose the firmware
> (as the unit has been unpowered for years)?
> Q: As I have only the application "binary" as a .vmc file,
> what would somebody suggests as a possible replacement?
> Best regards,
if you only need somebody to flush your C-Control and to install a .vmc file, you can send it
to me, i'm going to install it.